Body Trap Replacement Triggers individual
Bullseye triggers for 330/280 sized body grip traps. These triggers are made of heavy duty stainless wire (.104), and come complete with the hardware to replace your stock trigger. This "circle" trigger has a diameter of 6.5", however, it can be sized to your liking by opening or closing the circle. These wires will not rust, and will withstand years of use without breaking.
Battle Born
Battle Born removes a wife variety of paints, films, soils, wax, rust, and dyes. Does not pit or cause your traps to become brittle or otherwise adversely affect metals. Non-acid material requires no special container considerations.
Trap Pan Adjusting Tool
This handy tool fits all coil and long spring traps. You can use it to bend the cross frame of the trap where the dog attaches and raise or lower your pan level by pushing in or pulling out.
Sullivan's Trap Pan Tester
The Sullivan's trap pan tester is a handy tool used to measure the pan tension on your trap. Each mark represents 1 pound of pressure. The trap pan tester takes out all the guesswork! For fox and bobcats we recommend 2-3 pounds. For coyotes 3-4 pounds is good. When set the pan should not move until the animal puts some weight on the trap. This will help eliminate toe catches.
Ambush
Ambush is a revolutionary product that streamlines trap and snare prep with its integrated wax and dye formula. Comes in one gallon jug.
Bob Custer's B-2 Bender
This is the tool for every trappers work bench. Totally redone, it is now a fine-tuned piece of equipment. Makes J-hooks, swivels, baseplate rods, cotterpins, and more. You will find plenty of uses for this fine tool.
JC Connor Shock Spring
Best designed shock spring on the market. Decreases shock to the animal minimizing foot and shoulder injury. Keeps the stake from being pumped out of the ground. Die cut T-Bar with 1/4 inch hole to allow for easy hook up.
Body Trap Replacement Triggers dozen
Bullseye triggers for 330/280 sized body grip traps. These triggers are made of heavy duty stainless wire (.104), and come complete with the hardware to replace your stock trigger. This "circle" trigger has a diameter of 6.5", however, it can be sized to your liking by opening or closing the circle. These wires will not rust, and will withstand years of use without breaking.
Bench Mount Swager
This swager bolts to a work bench and is excellent for mass
production of snares, drowning slides, cable stakes, snare extension cables,
etc. Has multi-compression jaws to swage 1/16", 3/32",
1/8", 5/32", and 3/16" aluminum double ferrules and
aluminum stops. Very well made, heavy duty.
