Home > Fur Handling > Fur handling supplies
Sort By:
Page of 1
Plastic 2 hole Tail Stripper Plastic 2 hole Tail Stripper

Orange, plastic tail stripper.

Our Price: $2.95
Fur Hanger-individual Fur Hanger-individual

Easily holds a dozen fox pelts, or about 15 coons on a hanger. Just a great way to keep your fur up and out of the way after being removed from the stretcher.

$3.00 each or $30.00/dz

Our Price: $3.00
Winkler's Tail Zipper Winkler's Tail Zipper

Used to split the tail down the tip after the bond has been removed.  Very handy tool in the fur shed, and last a long time.  Makes a tedious job very simple and quick.

Our Price: $4.95
Fur brush Fur brush

Our Price: $5.95
Wiebe Tail Zipper Wiebe Tail Zipper

Foot to foot (money cut) and down the tail in just seconds.  The Wiebe zipper will save you enormous amounts of time.  The blade lasts and lasts yet can be replaced for just pennies.

Our Price: $7.85
#5 Moore's Push Pins #5 Moore's Push Pins

The original push pin.  Watch when you buy these because there are lots of after market push pins out there, and unless you enjoy lots of pins with pulled off heads, make sure you know what you're buying.  Bottom line:  if it doesn't say Moore on the package, they are not Moore push pins.  Pretty simple.

Our Price: $7.95
Standard Fur Comb Standard Fur Comb

Our Price: $8.95
Stone Mfg. Fur Comb Stone Mfg. Fur Comb

Our Price: $18.95
Table Mount Tail Stripper Table Mount Tail Stripper

This is a handy fur shed tool.  Once the tail is started around the base, just lay it into the "V" slot in the tool, give the handle a pull, and the tail is stripped.  It's spring loaded for speed.

Our Price: $21.95
Fur Hanger-dozen Fur Hanger-dozen

Easily holds a dozen fox pelts, or about 15 coons on a hanger. Just a great way to keep your fur up and out of the way after being removed from the stretcher.

$3.00 each or $30.00/dz

Our Price: $30.00
Duke Wire Fur Forms-choose size Duke Wire Fur Forms-choose size

These are available by the dozen in the following sizes:

#4 raccoon $62.95/dz
#5 xl raccoon $67.50/dz
#1 muskrat $34.95/dz

Our Price: $34.95
CCT Compact Skinner CCT Compact Skinner

The Compact Skinner will let every trapper be able to set up a skinning machine whenever needed. The bottom plate/D-ring assembly measures 7x5, which allows you endless adjustment for chain length, and also lets you pull to the floor. The kit also comes with 2-8 inch wide flat mouth grip locking pliers by CH Hansen welded to 48 inches of #3 USA machine chain, and the Bricker 100 skinning gambrel. The complete set to skin; all you need is a hoist. Compact, but ready to skin whatever you throw at it. Great for out of state trips, low overhead areas, and everyday skinner.

Our Price: $69.95